Remotely Control Icom Transceivers through an IP Network

• The RS-BA1 allows you to use the radio installed in another room using your home network or

even from a remote location over the Internet.

• Low voice latency (caused by the RS-BA1) provides the same operational experience as using an actual radio.

Advanced Remote Control Interface Tailored to Icom Transceivers

• Most functions and modes of your transceiver, including interference rejection functions and IF filter settings,

can be controlled. Also, S-meter and SWR can be observed.

• Rx Voice recording function.

❍ The RS-BA1 consists with two component software

applications; System configuration software and remote

control software. The system configuration software sets

up IP address, audio sampling rate and other settings. The

remote control software provides a user interface, similar to

the radio's front panel, and allows you to control the radio

from a remote location.

❍ The IC-7600, IC-7200 or IC-9100 can be connected to a PC

with a USB cable and the input/output audio signal and

CI-V command is sent through the USB cable.

❍ The IC-7800 or IC-7700 can be connected to a PC with a

RS-232C cable plus S/P DIF or ACC cable.

Standard accessories: USB cable (to connect the PC side radio with a radio with USB port).

1 - It 's plans to release an updated firmware for the radio with USB port for a better use of new features. Details will be announced in the future.
2 - The latency values below do not include those due to the network.
3 - The driver compatibility with 64-bit version is still being finalized
(Windows only accepts 7-64bit drivers with verified digital signature)
4 - Details of the IP features are still needed to be determined. - A basic knowledge of IP / router setting is essential to make the set up of the RS-BA1 and the use of a standard IP network.
5 - These figures do not include the latency of the network.